PRODUCT DATA SHEET:
E-500 M.I.O. For: Structural Steel
Systems
CHEMICAL FAMILY: Polyisocyanate-Prepolymer.
E-500: A one
component Moisture Cure Micaceous Iron Oxide, Pigmented, high build,
maximum strength, and high solids for Intermediate Paint, enhancing the ability
to sustain integrity of the whole system over the coatings life span.
E-500: Was also developed, especially, to
attain a high-build, rich red color, to contrast with other first coat primers
and most finish coats.
USES:
E-500 is excellent when used over our E-400 Aluminum
Moisture Cure Polyurethane Primer, also excellent when used under our E-600 Finish Coat.
E-500 is especially good for use as an overcoat system, over old lead paint
when cleaned @ visual S.S.P.C. CLASS 31.
Contractor friendly: E-500 is a one
component, easy to apply without blistering, cracking, when applied @ 8-10 mils.
Characteristics:
Wt. Solids: 80.89% +-2% Wt.
Vol> Solids: 65.53 Wt. Lbs. Per gal. 13.11
Viscosity: 85 K.IJ.
V.O.C. 2.51 lbs. per gal.
P.V.C. 34% P/B ratio 1.66
SURFACE PREPARATION: Surface must be free
of all grease, dirt, moisture and all other contaminants. Water blasting @ 4000 PSI
and power tool cleaning is recommended when product is used over old paint.
Application: Stir thoroughly, making sure
the product is of one consistency. Keep container closed when not using, as this
paint reacts with moisture.
Recommended film thickness: Apply 5 to 10
mils wet, depending of the needs of substrate.
Curing time: To cure, 4 hrs. To touch, 2 hrs. To handle, 3-4 hrs.
Recoat time: 4 hrs to 24 hrs, depending
on temperature and humidity. In cooler weather a longer drying time may prevail.
Equipment: Apply with airless sprayer,
tip size @ 0.013 to 0.0.17 or use roller brush.
Pot life: 3 to 6 hours, depending on
temperature and humidity. Product life: mm. one year.
Coverage rates @ wet film thickness.
4.5 mils = 210 sq, ft. per gal.
5 mils = 195 sq. ft. per gal.
10 mils wet = 100 sq. ft. per gal.
Sag resistance: No sag on LENATA DRAWDOWN
through 7 mils wet, 1/64" drag @ 9 mils wet.
Cleanup: Use XYOL [Xylene] to flush and
clean immediately after equipment use. Do not allow any alcohol near product or
equipment.
SAFETY PROCEDURES: SEE MSDS Sheet :(click here)
|
E-500 OVERCOATING System
School |
 |
 |
|
