PRODUCT DATA SHEET:
E-300 Moisture Cure Coal Tar Steel
Overcoat Systems, Polyurethane Top Coat TM
Description: Chemical Family:
Polyurethane Prepolymer. E-300 is a one component Polyurethane Moisture Cure
Coal Tar Coating. High Solids-High Build. Color: Brown, Silver, Black and
Bronze.
Uses: Recommended for harsh environments,
where Steel or Concrete is in Splash Zones or under Water, Water Treatment
Plants, Sewage Treatment Plants, Docks, Tanks, offshore Rigs & Dams.
E-300 allows smoother surface with less
Brittleness than the more conventional Two Component Epoxy Paints.
E-300 Benefits:
- One Component: Simply
Stir.
- Proven qualities against
weathering, chemical resistance and Abrasion.
- Excellent finish for over E-2800 Zinc Rich Primer, E-400,
E-500 M.I.O. and old Coal Tar Epoxy.
- Contractor Friendly: Can be
applied in lower than normal temperatures and higher humidity
environments.
- Believed to be superior to Epoxy Coal Tar
Paints, against cracking, abrasion and allows more
flexibility over the Coating life span.
- Quick-drying accelerators allowed.
Technical Data:
- Flash Point, @ or above 92F
- Weight Solids, = 76.70
- Volume Solids, = 61.50
- VOC, lbs./gal. = 2.80 - 340g/l
- Finish: flat to semi gloss
|
- PVC, % = 36.49.
- Weight Per gal, = 13.20
- Shelf Life, = One Year
- Pigment: Micaceous Iron Oxide
|
Application: (Spray,
Roller or Brush)
Clean up: Use Xylene, flush lines and
clean Equipment immediately. (Keep away from Alcohol). Surface must be free of
Grease, Dirt, and Pack Rust and any other Contaminants. Consult S.S.P.C.
WE RECOMMEND TWO COATS @ THE FOLLOWING FILM
THICKNESS.
Theoretical coverage:
1 wet mil=978 sq. ft.
12 wet mils=8.5 DFT
Recommended Dry Film Thickness: 5.0 -8.5 Mils. |
|
|
Curing Time , @ 72 Degrees F
- Touch 1/2 hr
- Re-coat 3-4 Hrs.
- To Handle: 24 Hrs.
- Hard dry: 48 Hrs.
|
|
To create a strong Barrier for added corrosion Resistance, use over our E-2800 Moisture Cure One Component Zinc Rich
Primer, or over our E-500 Moisture Cure M.I.O.
Primer/Intermediate Coat.
Immersion Specifications: SSPC-SP 10 Near
White Metal Blast, SSPC-SP6 Commercial Blast Clean.
Recommended Profile: 1.5 - 2.0 mil.
For Over-coating existing coatings:
Pressure Wash @ a minimum 3000 P.S.I Use other Cleaning Agents if necessary to
attain a desirable clean surface. Clean with power hand tools to SSPC-3 And
11.
For Over-coating EPOXY coating: use same
existing Coatings.
Safety Procedures: See MSDS Sheet
|
